● Managing the Hardware-In-Loop (HIL) Test-Lab project, being technical assistant to the CTO, system engineering, design failure mode and eect analysis (DFMEA) with ISO 26262, and setting direction for and coordination of electrical, mechanical, software teams. ● Project: Design, Development, and Management of Hardware-In-Loop (HIL) Test-Lab for Marine Electric Propulsion Systems.

● Automation of electrical tests and procedures, programming assembly units and development boards, optimizing the design of power electronics, amplifiers, and power supplies. ● Project: Automation of Electrical Tests, Procedures, and Data Acquisition.

● Design and development of power electronic converters, Control and drive of electric motors for robotic application, Hardware-In-Loop (HIL) test setup, programming micro-processors and control boards, functional safety features IEC61508. ● Project: Design and Development of Hardware-In-Loop (HIL) Test Setup for Autonomous Robotic Wheels. ● Project: HW/SW Design, Optimization, and Development of BDC Motors Closed-Loop Position Control Drive System for Robotics Application. ● Project: Design, Optimization, and Development of High Performance BLDC Motor Drive System for Robotics Application.

● Hands-on experience of Hardware-In-Loop (HIL) setup and programming of dSpace MicroLabBox RTI and FPGA boards, variable frequency drive systems, power converters, and electric motors. ● FEM analysis of electric motors using Ansys Maxwell. ● Demonstrable experience in use of structural analysis, signal processing tools, filter design, and control theory application. ● Project: Design & Development of Hardware-In-Loop (HIL) Test-Setup for Condition Monitoring of PMSM and Drive System with Real-Time Closed-Loop Field-Oriented Control Strategy and Data Acquisition System.

● Part of R&D team working on designing and fabricating gas fluid measurement devices, responsible for designing the human interface module. ● Experience in designing electronic circuits with DSP and ARM Cortex processors.

● Started as one of the first R&D members and worked on fault diagnosis of network devices and power electronics. ● Massive experience in fault diagnosis and repairing electronic modules. ● Project: Design & Development of Smart Charger for Ni-Ca Batteries in Ground Power Units. ● Project: Design & Development of Electronic centrifugal switch for single-phase Induction Motors. ● Project: Design & Development of Charge Controller for Lithium-Ion Batteries Fed by Solar Panel.